Recyclable and reusable Pd(OAc)2/PPh3/PEG‐2000 system for homocoupling reaction of arylboronic acids under air without base

A stable and efficient Pd(OAc)₂/PPh₃/PEG‐2000 catalytic system for homocoupling of arylboronic acids has been developed. In the presence of Pd(OAc)₂ and PPh₃, the homocoupling reaction of arylboronic acids was carried out smoothly in PEG‐2000 at 70 °C under air without base to afford a variety of symmetric biaryls in good to excellent yields. The isolation of the products was readily performed by extraction with diethyl ether, and the Pd(OAc)₂/PPh₃/PEG‐2000 system could be easily recycled and reused six times without significant loss of catalytic activity. Copyright © 2014 John Wiley & Sons, Ltd.     

Hexagonal boron nitride quantum dots: Properties,preparation and applications

As a new type of quantum dots (QDs), hexagonal boron nitride quantum dots (BNQDs) exhibit promising potential in the applications of disease diagnosis, fluorescence imaging, biosensing, metal ion detection, and so on, because of their remarkable chemical stability, excellent biocompatibility, low cytotoxicity, and outstanding photoluminescence properties. However, the large-scale fabrication of homogeneous BNQDs still remains challenging. In this article, the properties and common fabrication methods of BNQDs are summarized based on the recent research progress. Then, the corresponding yields, morphologies, and fabrication mechanisms of these as-obtained BNQDs are discussed in detail. Moreover, the applications of these as-obtained BNQDs in different fields are also discussed. This article is expected to inspire new methods and improvements to achieve large-scale fabrication of homogeneous BNQDs, which will enable their practical applications in future.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Structure determination of KScS2, RbScS2 and KLnS2 (Ln = Nd,Sm, Tb,Dy, Ho,Er, Tm and Yb) and crystal–chemical discussion

The title structures of KScS₂ (potassium scandium sulfide), RbScS₂ (rubidium scandium sulfide) and KLnS₂ [Ln = Nd (potassium neodymium sufide), Sm (potassium samarium sulfide), Tb (potassium terbium sulfide), Dy (potassium dysprosium sulfide), Ho (potassium holmium sulfide), Er (potassium erbium sulfide), Tm (potassium thulium sulfide) and Yb (potassium ytterbium sulfide)] are either newly determined (KScS₂, RbScS₂ and KTbS₂) or redetermined. All of them belong to the α‐NaFeO₂ structure type in agreement with the ratio of the ionic radii r³⁺/r⁺. KScS₂, the member of this structural family with the smallest trivalent cation, is an extreme representative of these structures with rare earth trivalent cations. The title structures are compared with isostructural alkali rare earth sulfides in plots showing the dependence of several relevant parameters on the trivalent cation crystal radius; the parameters thus compared are c, a and c/a, the thicknesses of the S—S layers which contain the respective constituent cations, the sulfur fractional coordinates z(S²⁻) and the bond‐valence sums.     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

Immobilizing redox enzymes at mesoporous and nanostructured electrodes

Three key challenges are stimulating intensive research in the development of productive direct electron transfer mode enzyme electrodes: proper enzyme orientation, high enzyme loading, and full retention of enzyme activity. In this review, we summarize some significant advances that have been reported in the last years on the design of mesoporous and nanostructured electrodes as enzyme scaffolds and of innovative methodologies for wiring enzymes to electrodes. Particular attention is given to investigations on physical factors that determine a favorable enzyme immobilization, to provide rational guidelines for the design of productive enzymatic electrodes. Finally, some emerging trends focused on the spatial organization of either single enzymes or enzyme cascades are also briefly addressed.     

Computational Design of Novel Allosteric Inhibitors for Plasmodium falciparum DegP

The serine protease, DegP exhibits proteolytic and chaperone activities, essential for cellular protein quality control and normal cell development in eukaryotes. The P. falciparum DegP is essential for the parasite survival and required to combat the oscillating thermal stress conditions during the infection, protein quality checks and protein homeostasis in the extra-cytoplasmic compartments, thereby establishing it as a potential target for drug development against malaria. Previous studies have shown that diisopropyl fluorophosphate (DFP) and the peptide SPMFKGV inhibit E. coli DegP protease activity. To identify novel potential inhibitors specific to PfDegP allosteric and the catalytic binding sites, we performed a high throughput in silico screening using Malaria Box, Pathogen Box, Maybridge library, ChEMBL library and the library of FDA approved compounds. The screening helped identify five best binders that showed high affinity to PfDegP allosteric (T0873, T2823, T2801, {"type":"entrez-protein","attrs":{"text":"RJC02337","term_id":"1480409465","term_text":"RJC02337"}}RJC02337, CD00811) and the catalytic binding site (T0078L, T1524, T2328, BTB11534 and 552691). Further, molecular dynamics simulation analysis revealed {"type":"entrez-protein","attrs":{"text":"RJC02337","term_id":"1480409465","term_text":"RJC02337"}}RJC02337, BTB11534 as the best hits forming a stable complex. WaterMap and electrostatic complementarity were used to evaluate the novel bio-isosteric chemotypes of {"type":"entrez-protein","attrs":{"text":"RJC02337","term_id":"1480409465","term_text":"RJC02337"}}RJC02337, that led to the identification of 231 chemotypes that exhibited better binding affinity. Further analysis of the top 5 chemotypes, based on better binding affinity, revealed that the addition of electron donors like nitrogen and sulphur to the side chains of butanoate group are more favoured than the backbone of butanoate group. In a nutshell, the present study helps identify novel, potent and Plasmodium specific inhibitors, using high throughput in silico screening and bio-isosteric replacement, which may be experimentally validated.